[PhilBot]

If the Driver Station saya "No Code" this means several things:

1) You have good communications with the robot (otherwise it would say no-comms)

2) You aren't running a robot program.

I haven't tried the release code yet, but It was my understanding that the cRIO image would NOT have a default program in it this year... that you'd need to "deploy" your own program....

So, if this was the case, doing a reset on the robot would cause it to behave as you have indicated. (no code)

Easy to test. First try running the program using the run arrow. This will deploy and run a "temporary" program.

If this works, then you need to do a "Build" and set it as the "run on startup" program. Then you should be able to do a reset and still have a running program.

Note: the flashing light status has changed this year. Blink off is good in teleop.