Whenever we try to run the Basic FRC cRIO Robot Project (no edits to code) and then move the joysticks nothing happens. And in the drivers station program the three lights are green (Stop button, Robot Code, and the other one that slips me at the moment). In the errors section it says something about lack of communication with the camera.
Setup
Test board wired to specs from
here under Hardware Documentation
with one sidecar and no signal light. Then off of the classmate is the 4 port hub (red and black usb in) and an ethernet cable going to the cRio (note no I/O). On the classmate Labview update and drivers station update applied (from above link, under software section) with nicyapi.dll added to windows/system 32.
Any ideas.