[yara92]

I read the GETTING STARTED
TABLE OF CONTENTS , Section 2
Set team number is OK.
I try to configure the classmate by to my PC I fail.
If this is not the classmate PC you should set the
© FIRST 2010 FRC Control System Manual: Section 1 – Introduction, Rev1 Page 32 of 58
address to 10.xx.yy.6 as the Driver Station defaults to 10.xx.yy.5 for its IP address. In this
text box, change the final digit .5 to .6..
My question is it the same config. As the last year
Component Default IP
(Team 0) Team Config
Wireless Bridge (on Robot) - 10.xx.yy.1
CRIO, port #1 10.0.0.2 10.xx.yy.2
CRIO, port #2 Not enabled 192.168.0.3
DS Wireless - 10.xx.yy.4
DS/ classmate 10.0.0.5 10.xx.yy.5
PC - 10.xx.yy.6
Camera 192.168.0.90 No change

Please if any one can help