[Technic-R-C]

Update:
The cRIO was reimaged (again.....) with V19 image and then an attempt was made to run sample code (again...) (the joystick sample code to be exact) No matter what USB setting we tried it did not work (tried two labtops). Afterwards I attempted to run a clean untouched 2010 FRC project. When built, ran as startup, and set to enable teleop in driver station mode, the camera image did not come up and when we moved the joystick the PWM values took extremely long to update on the dashboard. (1 second delays) I am out of ideas to what the problem could be.

Later the cRIO was imaged with JAVA and the code worked flawlessly. However I would like to know why LabView is not working. Any ideas?

Thank you

Regards

Technic-R-C