Thread: Driver Station not displaying Battery Voltage
View Single Post
  #3   Spotlight this post!  
Unread 27-01-2010, 11:43
Ziaholic's Avatar
Ziaholic Ziaholic is offline
Elec/SW Mentor
AKA: Marc
FRC #1164 (Project NEO)
Team Role: Mentor
  
Join Date: Jan 2008
Rookie Year: 2002
Location: Las Cruces, NM
Posts: 194
Ziaholic is a jewel in the roughZiaholic is a jewel in the roughZiaholic is a jewel in the roughZiaholic is a jewel in the rough
Re: Driver Station not displaying Battery Voltage
That was going to be my advice ... to NOT install the jumper on the input pins of the breakout ... but on 2 of those 3 pins in the upper corner of the board.

I'm also not near my 'bot, so I'm not sure which 2 ... but once you short them with the jumper, then you shouldn't wire anything up to input 8 on that breakout.
__________________
----
There are 10 types of people. Those who understand binary, and those that do not.
Team #1164 - Project NEO Robotics
Reply With Quote