|
Re: Troubleshooting solenoid breakout
If the 8 status indicators on the cRIO module itself are not lighting up, then the problem is before the Solenoid Breakout.
I assume the Driver Station Diagnostic tab status is all good?
The RSL is doing it's long on, short off sequence?
Then it's a LabVIEW coding problem.
Is the compressor code working?
P.S. Good error reporting by-the-way!
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 31-01-2010 at 15:48.
|