|
Re: how to set up 206 axis cam in labview
You should first connect the cam to your computer via a crossover cable. Then, run the Axis Cam Setup Tool, it will setup the cam's IP address and passwords. This must be done or the camera driver will not be able to find the camera.
Then, you should plug the camera in to port 2 on the cRio.
The code necessary to track a target is shown in the default code. You should be able to use it without too much work. Reading over it will explain how the camera software works.
__________________
Kettering University - Computer Engineering
Kettering Motorsports
Williams International - Commercial Engines - Controls and Accessories
FRC 33 - The Killer Bees - 2009-2012 Student, 2013-2014 Advisor
VEX IQ 3333 - The Bumble Bees - 2014+ Mentor
"Sometimes, the elegant implementation is a function. Not a method. Not a class. Not a framework. Just a function." ~ John Carmack
|