[chadr03]

We are trying to test our pneumatic system layout without using the controller programing right now. We are trying to simply use batteries and switches to control the compressor and solenoids. Once we have the system working properly we plan to integrate the programing and controllers. The pneumatics currently work as planned if we use the manual levers, but we have had no luck when trying to energize the solenoid using a battery (Tried both 12 and 24V). The indicator light comes on but the valve is not switched. Is this a reasonable way to test these solenoids or do they need to be hooked to the controller and the solenoid breakout panel.

We have tried both the festo double acting solenoid and the single acting. Same results. The manual switching opens and closes the valve, but the battery just lights up the light with no movement of the valve.

Any help would be much appreciated.