Quote:
Originally Posted by Mike9966
So, on this Y cable idea. I tried this past weekend to run 2 Jag's from one pwm output and anytime I plugged in the second Jag, neither would work.
I ended up being able to only run 1 motor for the test because of it.
Are we sure the 1pwm to 2 Jags via a Y cable is supposed to work?
Thanks
Mike
|
1 PWM port can provide signal for any one of the following combinations:
- 1 Servo
- 1 or 2 Victors
- 1 or 2 Jaguars
You can not have one PWM port provide signal for a Jaguar and a Victor. The Victor draws much more signal current than the Jaguar and essentially starves it.
I made sure that a single PWM port can provide more than enough signal current for two Jaguars always. In fact, the circuit is beefy enough for three (or four >80% of the time) Jags.
Can I ask which PWM port(s) you were using? Are you sure you didn't have one of the PWM cables upside down?