Thread: Analog Input tied to Accelerometer on Cypress
View Single Post
  #1   Spotlight this post!  
Unread 04-02-2010, 23:55
offramp13 offramp13 is offline
Registered User
FRC #1425
  
Join Date: Feb 2010
Location: Wilsonville, OR
Posts: 1
offramp13 is an unknown quantity at this point
Analog Input tied to Accelerometer on Cypress
I've set our driver station up and installed the mandatory update. Now I'm trying to get all the I/O ports confirmed working. I used the PSoC Programmer to load the "FRC_IO.v2.hex", but I have run into a problem. The 8 analog ports displayed on the FRC Driver Station in advanced mode fluctuate with acceleration in the Z axis.

I am not sure if this is a configuration problem or if it is a problem with the hex code itself. Has anyone run into something similar to this?

Thanks in advance.
Reply With Quote