Thread: Continued problems with Cypress I/O Board
View Single Post
  #2   Spotlight this post!  
Unread 07-02-2010, 02:55
jhersh jhersh is offline
National Instruments
AKA: Joe Hershberger
FRC #2468 (Appreciate)
Team Role: Mentor
  
Join Date: May 2008
Rookie Year: 1997
Location: Austin, TX
Posts: 1,006
jhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond repute
Re: Continued problems with Cypress I/O Board
Quote:
Originally Posted by pheisinger View Post
The PSOC Programmer finds our Cypress board fine and successfully downloads the Hex file.

However, the driver station does not see the Cypress board. As suggested in another thread, we have uninstalled and reinstalled (now 4x) the mandatory update for the Cypress board - no luck. Any ideas would be appreciated.
Go to Control Panel and check that the Cypress Mini Prog 3 service is configured for auto startup and is running.

Are you sure the drivers are installed correctly? Go to device manager and look under the USB heading. Make sure you see the board listed and that it is not "Unconfigured".

Also, if you press the Button on the board, do the LEDs light up and show you the firmware version of 2 in binary (the second LED lights)? This only works if the driver station is not talking to the board.

-Joe
Reply With Quote