[aechmtwash11]

I think I need to better explain my questions.

On the safety pressure release, we are trying to fit the system in a very small spot. So we are trying to fit all the FIRST required sensors and such to be on the side of the compressor with the motor. Because of this it is requiring us to have the pressure release between a set of T's and the compressor. (is this allowed?)

Flipping the top of the compressor was just to make it easer so we wouldnt have to go through another down-sizer

On the pressure regulater, we are having the air flow immediately split into two systems once it exits the compressor. So essentially we have a system for the right side of the robot and a system for the left. So can we have two main regulators?

We have checked the pnuematics manual but it says on the first page that it is just for suggestions and are not official rules.

Thanks Again,
Austin
2783=2010