|
Re: Connecting Two motors to one Jaguar Controller?
Quote:
Originally Posted by Mark McLeod
One motor per Jaguar.
Quote:
< R55> All electrical loads (motors, actuators, compressors) must be supplied by an approved power regulating device ( speed controller, relay module, or Digital Sidecar PWM port) that is controlled by the cRIO-FRC on the ROBOT.
A. Each CIM motor and Fisher-Price motor must be connected to one and only one approved speed controller. These motors must not be connected to relay modules. |
I believe that rule says one controller per motor. I remember in 2005 we ran two FP motors on one victor because we got the 6V FP motors, and that was legal. I see no advantage to run two motors off of one controller other than cost savings.
The only repurcussion I can think of is that you'll only be able to utilize part of the power of two cims as your electrical power will be limited to ~420watts. Of course it will also be a whole lot easier to pop a single 40Amp breaker with 2 CIMs.
__________________
Theory is a nice place, I'd like to go there one day, I hear everything works there.
Maturity is knowing you were an idiot, common sense is trying to not be an idiot, wisdom is knowing that you will still be an idiot.
|