Quote:
Originally Posted by umangv620
That is actually a good idea! I never knew that little thing on the front of the joystick was Axis 3.
btw(by the way), i created a post JUST like this, but I have code that does work(with the lightbulb on). I am still trying to figure out why the camera servo itself isnt working when we deploy the code.
|
Make sure you have a jumper on the pwm channel your using for the servo.
Also I have a question:
Im using axis 3 as a throttle to control the speed for our robot. Basically I wana be able to move it down to make our robots motors run slower so going over the bump isnt so fast and reckless.
I did it with controls, but I wana do this with the actual axis 3 button.
How would I go about doing it. These two are what I have:
