[hrldcpr]

We just have it connected into channel 1 of the analog breakout, +5v to +5v, ground to ground, signal to signal. (But we've tried other channels too, and just powering it directly.)

The analog breakout is working as far as I can tell, i.e. it's definitely providing the correct supply voltage, though once we hook it up to the gyro board that voltage gets pulled negative which is obviously not good.

I don't expect there's a simple solution, just hoping for some electronics genius to realize that one of the capacitors on the gyro board is dead or something so all we have to do is replace that instead of getting a whole new gyro. But yeah I think we'll end up getting one of the sparkfun breakouts.

Thanks for your input!