Thread: Pressure switch problem
View Single Post
  #1   Spotlight this post!  
Unread 16-02-2010, 20:30
Wiz Wiz is offline
Registered User
no team
  
Join Date: Dec 2009
Location: New Hampsha
Posts: 18
Wiz is infamous around these partsWiz is infamous around these parts
Question Pressure switch problem
Hey everyone

We have put a pressure switch on our pneumatics system. I programed it to turn of the compressor, but I don't know how to set the pressure it should turn off at. When the compressor runs, the pressure will go up to 110 psi then run out the release valve. Does anyone know how to program a pressure switch to turn of a compressor?

I want the pressure to switch the compressor of at about 100 psi

I am using labview, I am also a first year programmer, so please keep it simple.

thanks