Thread: Programming the Cypress Board
View Single Post
  #2   Spotlight this post!  
Unread 20-02-2010, 15:08
misko misko is offline
Registered User
FRC #0852
  
Join Date: Dec 2009
Location: California
Posts: 22
misko is an unknown quantity at this point
Re: Programming the Cypress Board
The Cypress board should be plugged into the USB on the drive station. Then just use the drive station routines like GetDigitalIn and SetDigitalOut. Check the DriverStation documentation in the help found in your WindRiver docs/extensions/FRC directory.
Reply With Quote