Thread: PWM cables in Inventor
View Single Post
  #2   Spotlight this post!  
Unread 21-02-2010, 20:34
mpinventor19 mpinventor19 is offline
Registered User
FRC #0514
  
Join Date: Feb 2010
Location: New York
Posts: 8
mpinventor19 is an unknown quantity at this point
Re: PWM cables in Inventor
We literally just asked ourselves that question today. We had the idea of using the ribbon cabel comand to create the PWM Cables. If you have a better solution we would like to hear it but we also are still trying to figure out the Ribbon Cable command on inventor.