[gokul]

Hi All,

Has any one used the enhanced mode on the Cypress SPoC and played with the ANALOG OUTPUTS ?

I have used the compatibility mode and am able to get the ANALOG INPUT working fine (except for the high impedance noise on the unused AI lines).

I have been able to use switches on the PSoC and reflect the switch settings back to the (virtual) LEDs on the DS - so far so good.

I am using Windriver C++ and the standard DriverStation class.

Is there a Analog Out method in the DirverStationEnhanced class that can be used to send an analog signal back ?

Greg M may know the answer to this (also!) ...

It would be nice to have a manual about PSoC as applied to our FIRST scenrios.

Many thanks in advance.
Gopal