Quote:
Originally Posted by PaulRevere
We disconnected our Bridge from the cRIO’s Ethernet port (#1), and tethered the robot to our router, and it was fine. But, if we switched back to wireless, it resulted in the same thing. (Code aborts, stuttering video, etc.) This morning, one of our programmers tried the wireless again, still to no avail. He then turned off the robot, went over to get a drink, came back, turned on the robot, and low and behold, the wireless link was fine!
|
Please describe for us how you have power connected to the Bridge on your robot. Might the plug be slightly loose? Might the wires have an intermittent open where they are inserted into the white Wago connector, or perhaps even an intermittent short across them?