[Travis Hoffman]

I am experiencing similar problems - last year's code downloads and executes fine. Creating a new shell based on last year's project, writing new code, compiling it without issue, downloading it perfectly, and rebooting yields "no robot code". Extremely frustrating.

As far as I can tell, I've updated every and all piece of software and firmware to current versions. If there is a magic spiffy-dee-do installation order that must be followed in order to get everything to mesh properly, I don't see the corresponding magic spiffy-dee-do DOCUMENT that informs end users on what that process should be.

I am seeing a lot - too many - of these WindRiver "No Code" issues from many people of late - I did not have any problems at all with this using last year's stuff. Is anyone "in charge" doing anything constructive to address these issues, as some appear to still be stuck?

Also, I'd like to know (and I thought I knew, as I did it last year several times successfully) how to rename a project, the build paths/specs, yadda yadda from one project name to another. Example - "DefaultRobotProject" to "XM12", such that the end result is a binary XM12.out. Again, I did this last year in modifying 1114's beta test code with no major issues.

Disclaimer - I am not a hardcore C programmer.

Thanks in advance,