Quote:
|
Team 39 used a much simpler system where three valves fed into one pneumatic cylinder."
|
At the Sat scrimmage I saw what Matt spoke of... don't remember the team.
One team had ordered a large bore cylinder from BIMBA that had multiple ports feeding each end of the cylinder which allowed more than one valve to feed the big mother hence increasing the effective flow rate.
This is probably legal based upon the rule:
D:...Cylinders may be of any configuration, and may be of any size up to a maximum of 24-inch stroke and 2-inch diameter.
but I'm concerned that it violates the intent of the valve port/Cv size limits.
Any thoughts?