|
Re: Quadrature Encoder Wiring to Digital Sidecar
The Labview Encoder Example has a picture of the wiring on the Front Panel.
Basically you want to use 1 full row of the Digital I/O on the Sidecar + 1 signal pin on an adjacent row. Wire +5 to the middle pin of the row, GND to outside pin (on the outside of the Sidecar), and Channel A to the inside pin of that row (Signal pin). Channel B should be wired to the Signal pin (inside pin) of an adjacent row.
__________________
2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)
|