Thread: legality of bolt and screw heads breaking plane of chassis meeting bumpers
View Single Post
  #44   Spotlight this post!  
Unread 02-03-2010, 01:27
eugenebrooks eugenebrooks is offline
Team Role: Engineer
AKA: Dr. Brooks
no team (WRRF)
  
Join Date: Jan 2004
Rookie Year: 2001
Location: Livermore, CA
Posts: 601
eugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond repute
Re: legality of bolt and screw heads breaking plane of chassis meeting bumpers
Here is a QandA that does not address this question directly,
but is quite close.

Join Date: Jan 2010
Posts: 1
Warped Bumpers
We manufactured two sets of bumpers early in the build, to the specifications of <R07>. Since then, we have mounted the bumpers on the robot and found the 3/4" plywood has warped, making them slightly convex. Do the bumpers have to be in contact with the frame through the entire length of the robot?
#2
02-15-2010, 11:35 AM
GDC
Game Design Committee

Join Date: Jan 2006
Posts: 2,401
Re: Warped Bumpers
Yes. Please refer to Rule <R07-M>. The BUMPERS have to be supported along their entire length.