|
Re: Programming Pneumatics
In Begin.VI you should have:
Compressor Open -> Compressor Start -> Compressor Refnum Set
Finish.VI should have:
Compressor Refnum Get -> Compressor Stop -> Compressor Close
You don't need anything in Autonomous or Teleop for the Compressor, the Start command spawns a separate thread that runs during both modes.
__________________
2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)
|