|
Re: cRIO issues (Imaging and deploying)
Which safe mode instructiojns were you referring to? I only saw the section that said to boot into safe mode and run the tool. Is there anything more in depth?
After trying that, I still couldn't see the cRIO from the scanning tool. A ping also failed, in both safe mode and out of safe mode. While in safe mode, the status light on the cRIO would blink orange three times, then pause for a bit. I don't know if this is normal safe mode behavior or if it means anything.
Is there a general way to reset the cRIO to factory settings? I see the reset button, but I don't know exactly what it resets.
__________________
When all else fails, read the manual.
FRC 1713 K Island Gears 2009, 2010 (Not 2011 due to budget, hopefully 2012!) - Fingerlakes Regional
FTC 4356 The Zip Ties 2010-2011 Season - NNYRC (2010 9th seed).
Last edited by EthanMiller : 25-03-2010 at 07:51.
Reason: Additional info.
|