|
Re: No Battery Voltage
Make sure you have the correct version of both the DS (10.02.08.00) and cRIO image (2010_V20).
Also make sure the analog module is properly plugged into slot 1 of the cRIO. The analog breakout should be plugged into the Analog module and powered. Make sure the power LED on the analog module turns on when the robot is powered.
The last thing to check is that the jumper is properly installed on the outside two pins of the 3 pin header on the Analog breakout. Also if you have a different jumper to try, switch it out, I've heard a team or two that had a broken jumper and swapping it out fixed the problem.
__________________
2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)
|