[johncap100]

well i have set up the wet 610n bridge as instructed in the directions.
I have reset the router and the two will not communicate. I can connect the bridge directly to the computer and there is good communication, i can connect the bridge through the router to the computer and there is good communication from the computer to the bridge via the router, but if i disconnect the bridge in any way from the computer there is no communication. I have gotten the new bridge to solve these problems, to no avail. I guess the next step is the get another router and try that, there just seems to be a communication issue between the bridge and router. any ideas?
is there a way to somehow find out if the router is sending out signals correctly to the bridge, i had felt that the old bridge was the issue, but now ii may be the router.

thanks