Thread: Set Jaguar device number via cRIO
View Single Post
  #5   Spotlight this post!  
Unread 05-09-2010, 02:18 PM
kamocat's Avatar
kamocat kamocat is offline
Test Engineer
AKA: Marshal Horn
FRC #3213 (Thunder Tech)
Team Role: Mentor
  
Join Date: May 2008
Rookie Year: 2008
Location: Tacoma
Posts: 894
kamocat is just really nicekamocat is just really nicekamocat is just really nicekamocat is just really nicekamocat is just really nice
Send a message via AIM to kamocat Send a message via MSN to kamocat
Re: Set Jaguar device number via cRIO
Yes, the LED is blinking yellow. If I plug in a PWM cable, Normal PWM operation works perfectly (including the LED, brake, coast, and the limit switches).
If I connect another Jaguar on the CAN bus, it shows no change.
However, I think I made a mistake in a previous test. It makes no difference whether the termination resistor is present or not. It should be 120 ohms, and connecting the CAN low and CAN high, correct?
__________________
-- Marshal Horn
Reply With Quote