View Single Post
  #2   Spotlight this post!  
Unread 11-05-2010, 13:59
Jeff 801's Avatar
Jeff 801 Jeff 801 is offline
Registered User
no team
Team Role: Alumni
 
Join Date: Jun 2006
Rookie Year: 2004
Location: Florida
Posts: 346
Jeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond reputeJeff 801 has a reputation beyond repute
Re: pic: 3 Hour Chassis + 2 Hours

If you can I would get the extended output shaft that AM sells and make the center wheel direct drive.

Also how do you plan to tension the chains that your using and what size chain are you looking at?

Also the chain runs on the bottom look like they will run into the square tube... In inventor with design accelerator you can generate chain runs so that you can check for clearance. If you in solidworks I think there is a way to do the same thing.

Last edited by Jeff 801 : 11-05-2010 at 14:12. Reason: More questions
Reply With Quote