|
Re: Set computer to receive it's IP via DHCP?
If you connect and change the bridge IP to be compatible with the preferred robot setup, then after rebooting the bridge you must make your PC IP also compatible with the robot setup before you will be able to talk with the bridge again.
Assuming your PC is connected directly to the bridge...
After you set the bridge IP to 10.8.42.1
you must reset the PC IP to 10.8.42.6
then you should be able to browse to the bridge again.
Did you start from resetting both the bridge and router to factory defaults, or are you just resetting the bridge, since the router is probably fine already?
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 19-05-2010 at 22:42.
|