|
Re: pic: Prototype Drivetrain
Quote:
Originally Posted by M.Wong
Instead of welding the pieces together, I would recommend using these Brunner Connectors. We've been using these for quite a while. Just make some 1/8" thickness aluminum gussets and some self-tapers in order to secure the pieces together. |
Along the same lines, we've used 80/20 quickframe which is nearly identical to the Brunner stuff but the pricing is lower. We normally rivet 1/16" lexan to tie the frame together. We've had good luck with this method the last couple years.
__________________
"Engineering is making the impossible happen"
"We are here to create, not merely survive" - unknown fortune cookie 
"If you don't push the envelope you're just spinning your wheels"
|