|
Re: pic: 3 Motor Single Speed Gearbox
Looks really nice thus far. You may want to search cd-media for our 2008 drivetrain. I designed it to be a 6 motor (4 CIM, 2FP) single speed drive system with 4.75" wheels. Just something comparable to look at.
If I am interpreting your question correctly you were asking about clearance inside the gearbox. Be sure you give yourself some clearance for tolerance stack up. If you don't, when you tighten everything up your gearbox could be seized up, or you may even damage your bearings.
The motor screws are completely legit to use as a method to hold the gearbox together.
Keep up the good work.
-Brando
__________________
MORT (Team 11) '01-'05 :
-2005 New Jersey Regional Chairman's Award Winners
-2013 MORT Hall of Fame Inductee
NUTRONs (Team 125) '05-???
2007 Boston Regional Winners
2008 & 2009 Boston Regional Driving Tomorrow's Technology Award
2010 Boston Regional Creativity Award
2011 Bayou Regional Finalists, Innovation in Control Award, Boston Regional Finalists, Industrial Design Award
2012 New York City Regional Winners, Boston Regional Finalists, IRI Mentor of the Year
2013 Orlando Regional Finalists, Industrial Design Award, Boston Regional Winners, Pine Tree Regional Finalists
2014 Rhode Island District Winners, Excellence in Engineering Award, Northeastern University District Winners, Industrial Design Award, Pine Tree District Chairman's Award, Pine Tree District Winners
2015 South Florida Regional Chairman's Award, NU District Winners, NEDCMP Industrial Design Award, Hopper Division Finalists, Hopper/Newton Gracious Professionalism Award
|