|
Re: dip switch positions?
All DIP switches should be off normally.
You'll see the word OFF on one side and the switches should be pressed down on that side to be off.
Although USER1 doesn't matter. That one's just there if you want to signal your code about something.
CONSOLE OUT can be on unless you are using the cRIO serial port for CAN.
P.S.
In that picture on page 33 the SAFE MODE switch is the only one ON, the others are all OFF.
"I/O unit not detected or not installed correctly" just means the Cypress I/O board isn't detected or attached via USB to the Driver Station.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 28-08-2010 at 17:51.
|