View Single Post
  #2   Spotlight this post!  
Unread 26-09-2010, 19:47
Andrew Remmers's Avatar
Andrew Remmers Andrew Remmers is offline
Registered User
AKA: Andrew Remmers
no team
Team Role: College Student
 
Join Date: Nov 2007
Rookie Year: 2007
Location: Orlando
Posts: 390
Andrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond reputeAndrew Remmers has a reputation beyond repute
Send a message via AIM to Andrew Remmers
Re: [FTC]: CAD Question

I'm going to go out on a limb here and say along with all of the above. I think the addition of something I think could be nice. What about the addition of some "heavy pneumatics" Not lego with the restricted stroke, but something like an SMC piston with very small bores and a small air accumulation system. It was just one of my crazy thoughts

Also, what about a gear that fits inside the channel?

P.S. Homemade FTC bevel gears are not fun to make...

Andrew
__________________
Exploding Bacon 2007-2011

Built and Dangerous (B.A.D) 2011-2012

Community Mentor / School Break 2012-2014

North American Robotics: The MooseEagles Founding Member 2012-Present (VEX U)


Last edited by Andrew Remmers : 27-09-2010 at 12:24.
Reply With Quote