|
Re: Cannot download default Code
I can confirm that after a re-image the Robot Code light will indeed be red, until new code is successfully downloaded.
That image in the Control System Manual is incorrect.
I assume your new LabVIEW default project has the correct IP entered as well (10.12.8.2)?
I'll see if I can repeat the issue you're seeing by mucking around a bit.
P.S.
I think we only see the Timeout message if there's been at least an initial successful handshake between the PC and cRIO.
Otherwise, the usual message is "Target not found."
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 27-09-2010 at 20:17.
|