Thread: I need some live axil design tips!
View Single Post
  #1   Spotlight this post!  
Unread 01-10-2010, 19:19
Hawiian Cadder's Avatar
Hawiian Cadder Hawiian Cadder is offline
Registered User
AKA: Isaak
FRC #0159 (Alpine Robotics)
Team Role: CAD
  
Join Date: Feb 2010
Rookie Year: 2003
Location: Fort Colins Colorado
Posts: 573
Hawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to all
Re: I need some live axil design tips!
a little advice to you, DONT USE LIVE AXLE DIRECTLY OFF BANE BOTS P80's the e rings inside the gearbox break all the time, then they have to be taken apart and fixed.

we typically use collars, but we taper the edge on a mill or with a grinder so that the edge of the collar does not rub against the bearing seal. key-stock or hex broached axles are necessary to drive the wheel. with live axles i also would recomed a larger diameter of axle, while 1/4 or 3/8 axle is fine for dead axle, 1/2 or 5/8 is better for live axle, good luck.
Reply With Quote