View Single Post
  #1   Spotlight this post!  
Unread 03-11-2010, 11:32
ATCMech ATCMech is offline
Registered User
FRC #1251
 
Join Date: Nov 2010
Location: Coconut Creek FL
Posts: 6
ATCMech is an unknown quantity at this point
Three Wheeled Scooter

We are working on building a 3 wheeled scooter in which there are two large wheeles in the front that are powered and control steering with 1 smaller swivel wheele in the back for stability. so far we plan on using an analog joystick. Below is our supplies so far... also, would we be able to use the speed controller below as a micro controller as well... We plan on running 24volt batteries.

--------------------------------------------------------------------------------



Motors
$286 ea.
http://www.npcrobotics.com/products/...at=20&mode=gfx

Wheels
(front)
$73 ea.
http://www.npcrobotics.com/products/...at=21&mode=gfx
(back)
http://www.google.com/products/catal...d=0CFIQ8wIwAA#

Wheel Hubs
$20
2x
http://www.npcrobotics.com/products/...at=18&mode=gfx
NPC-PH448

Speed Controller
$145
http://www.robotcombat.com/marketplace_roboteq.html

Driver
????


Joystick
$35
http://www.mouser.com/ProductDetail/...pKNhOQSs/po%3d

Batteries
$65 for 2
http://www.monsterscooterparts.com/24vo10amphob.html


Fuses/Fusebox
*need help (we beleive we'll need 40A fuses)


---------------------------------------------------------------------------------------------------------------------------------------------------
We just wanted to make sure that all our supplies are compatible as well.

If you have any comments or suggestions we would love to hear them.......
Thanks for replying

Last edited by ATCMech : 03-11-2010 at 11:52.