|
Re: Fan Power
The simplest solution is to run the fans from a single circuit breaker on the power distro board. They will turn on when the robot is turned on. The electrical rules require a #18 wire be connected to the PD but you may buss several fans together and then tie them to the #18. Insulation is required on the exposed wiring, the use of heatshrink tubing is highly recommended.
Using a Spike to control fans under software control is an acceptable option as well.
__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.
|