|
Re: [FTC]: C-Rio cant connect to target...again
In order to do a "Run" operation I beleive the cRIO has to unload the currently running application. This may be what is causing your problem.... It may not be being unloaded sucessfully.
One alternative that is easy to try is to set the DIP Switch on the cRIO to tell it not to run anything on startup... thus leaving the processor free to load your new program.
You'll need to check the manual, but if you flick that switch and reboot, the robot will start up "naked". You can always put the switch back to get your normal run-on-startup behavior.
__________________
Phil Malone
Garrett Engineering And Robotics Society (GEARS) founder.
http://www.GEARSinc.org
FRC1629 Mentor, FTC2818 Coach, FTC4240 Mentor, FLL NeXTGEN Mentor
|