[ATannahill]

Originally Posted by nighterfighter

Also, page 25: Step 11-

And on page 29,



You can also use these kind of connectors-
http://www.frys.com/product/2608042[/qoute]

As discussed in another thread, fully removing the screws can get metal shavings in the motor controller.

Originally Posted by nighterfighter

And on the last page, page 34, you might want to mention that for connecting wires to the Spike Relay, use spade connectors-
http://www.frys.com/product/2604252?...H:MAIN_RSLT_PG

While that does seem to be the right part number, it is important to note the picture show a male connector instead of the female version that should be used. Be sure to get the right size for the wire being used.