Thread: A little question about the robot size.
View Single Post
  #3   Spotlight this post!  
Unread 09-01-2011, 13:43
Trent B Trent B is offline
College Mentor
AKA: Trent Borman
no team (Surviving Grad School)
Team Role: Alumni
  
Join Date: Dec 2008
Rookie Year: 2008
Location: Ames, IA
Posts: 479
Trent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to behold
Send a message via AIM to Trent B Send a message via Yahoo to Trent B
Re: A little question about the robot size.
Because it has to fit in a 60" cylinder (as of right now, the metric number is different) we took the time to calculate out the total length of a robot + arm if it is 28" wide

We found that it could be 56.5" long. If your robot wasn't even an inch wide you would be able to be 60" long (essentially the diameter of the circle)

Equations here http://en.wikipedia.org/wiki/Circular_segment



h(sub robot-width) is the width of your robot opposite the manipulator.
h(sub manipulator width) is the width of your manipulator (at its point furthest from the opposite side of the robot when it is parallel to the ground causes your manipulator to extend as far as possible (cos theta where theta = 0 in this case)
Attached Thumbnails
Click image for larger version Name: CodeCogsEqn.png Views: 2 Size: 6.2 KB ID: 9608  
__________________
Former 2502 (Talon) Captain and 3928 (Neutrino) Mentor, currently teamless and attending Penn State for graduate school.
Have questions about Iowa State University or Penn State University? Feel free to email or PM me
Last edited by Trent B : 09-01-2011 at 13:54.
Reply With Quote