Thread: New Router?
View Single Post
  #26   Spotlight this post!  
Unread 12-01-2011, 12:12
DavidGitz's Avatar
DavidGitz DavidGitz is offline
Lead Technical Advisor
FRC #1208 (MeTool Brigade)
Team Role: Coach
 
Join Date: Dec 2006
Rookie Year: 1996
Location: O'Fallon, IL
Posts: 341
DavidGitz has much to be proud ofDavidGitz has much to be proud ofDavidGitz has much to be proud ofDavidGitz has much to be proud ofDavidGitz has much to be proud ofDavidGitz has much to be proud ofDavidGitz has much to be proud ofDavidGitz has much to be proud of
Send a message via AIM to DavidGitz Send a message via MSN to DavidGitz Send a message via Yahoo to DavidGitz
Re: New Router?

We are still having issues. We also did the 30-30-30 reset and received the Emergency screen. From there we updated the firmware and were able to get into the bridge. We followed the bridge configuration document and setup the Bridge part first and then setup the Access Point part of the document, saving all changes in the process.

After this setup is complete, we can hook up a wired connection from a laptop, a wired connection from the classmate and a wired connection all to the Bridge, ping all devices and were able to run the Tele-Op and Autonomous Modes (default code) successfully.

All wireless testing is done with the wired connection removed.

With the Bridge in "Bridge Mode", and 1 laptop with windows 7 and the classmate, neither computer can connect wirelessly. The classmate and windows7 laptop do not see the 1208 network at all. The Robot is about 2 feet away from all devices in question. The "Bridge Light" blinks on and off.


With the Bridge in "AP Mode", we get the same results as above. The "Access Point Light" blinks on and off.

Anybody have a clue?
__________________
Reply With Quote