Thread: V - Belt
View Single Post
  #1   Spotlight this post!  
Unread 07-31-2012, 02:10 PM
pigpenguin's Avatar
pigpenguin pigpenguin is offline
Registered insane
AKA: Ethan Rooke
FRC #1160 (Titanium Robotics)
Team Role: Mentor
Join Date: Apr 2008
Rookie Year: 2008
Location: L.A
Posts: 43
pigpenguin is an unknown quantity at this point
V - Belt

So I have been working on a drivetrain cad model that uses v-belt as its primary transmission system. I have run into a small problem in the design accelerator. The v belt dimensions that I would be using are not in inventor. So I was curious if there was any way to add your own profile to the design accelerator. Thanks ahead of time,

"Insanity isn't a plea its a way of life and here we are all one card short"