|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Alan,
We built a 1/2" version of the Dr Joe's Drill Shaft. We had to replace the internal bearings in the housing with a bushing. This allowed us to use 1/2" bearings and No. 35 sprockets in the drive train. We used this the last two years without any problems. Andres |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|