|
|
|
![]() |
|
|||||||
|
||||||||
| View Poll Results: What do you use for chassis material? | |||
| wood |
|
11 | 5.07% |
| steel angle |
|
8 | 3.69% |
| aluminum angle |
|
36 | 16.59% |
| steel tubing (round or rectangular) |
|
2 | 0.92% |
| aluminum tubing (round or rectangular) |
|
58 | 26.73% |
| Bosch extrusion or similar (aluminum or steel) |
|
89 | 41.01% |
| Other |
|
13 | 5.99% |
| Voters: 217. You may not vote on this poll | |||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#30
|
|||
|
|||
|
That is a very good point to not paint lexan. Generally plastics dose not like to be sprayed with solvents(which spray paint is). They tend to weaken them by eating little holes in them. Thus, as you know, they become weak and brittle. 1/4" Lexan is about the weakest lexan you can find. The lexan used in the demo was most likly of 3/4" to 1" thick lexan.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Image Discuss: Team 190 - Completed chassis | CD47-Bot | Robot Showcase | 17 | 20-02-2003 17:37 |
| Image Discuss: Chassis Teaser | CD47-Bot | Robot Showcase | 4 | 10-02-2003 23:00 |
| the provided chassis material | Andrew Dahl | Kit & Additional Hardware | 5 | 09-01-2003 15:26 |
| Sheet Aluminum Chassis: | fs_2002 | Technical Discussion | 4 | 17-10-2002 10:10 |
| Chassis | ark_1230 | Technical Discussion | 2 | 04-09-2002 22:51 |