|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
|
|||||
|
|||||
|
Well the FP Transmission is finally completed and posted in the mechanical library of the FIRST CAD Library. This one was tough. Injection molded stuff is a pain to draw and be warned that I had to make a few judgement calls and assumptions. The model is close but if you are going to make a part to capture the housing then I would invest a little time in comparing the model to your actual part. I tried to pay close attention to the end of the model where the output shaft is. The 3 screw pattern and the final gear shaft are pretty close to the FP transmission I have.
BTW This part is metric (mm) FIRST CAD Library |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Locking the Bosch 3360 Drill in low gear | CD47-Bot | Extra Discussion | 4 | 05-08-2003 02:10 |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| Replacement Bosch drill motor assembly | james700 | Motors | 3 | 31-01-2003 21:08 |
| Should FIRST include Bosch Drill Motors in Next Years Kit of Parts | mtaman02 | Motors | 9 | 05-07-2002 16:32 |
| BOSCH Drill Transmission Assembly | archiver | 2001 | 2 | 23-06-2002 22:08 |