|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||||
|
||||||
|
Working On It.
I have contacted the motor manufacturer's for the following motors:
1. Drill Motor 2. Atwood Chiaphua 3. F-P motor 4. Window Motor I suspect that the globe motor is the same as last year (look in Dr. Joes Motor Spreadsheet in the White Papers section). I also suspect that the only difference in the Atwood is the shaft, but will confirm. The Atwood from last year has the following performance specs: 1. Stall Torque = 2.2 N-m 2. Free Speed = 5500 RPM 3. Stall Amps = 107 4. Free Amps = 2.3 The Atwood Shaft diameter is: ~7.92mm. This is probably an 8mm shaft undersized by 0.05 to 0.10 mm. The keyway is made for a standard 2mm square key (included in kit). I want to warn you about the F-P motor!!! The specs in the FIRST manual are for lasts year's Johnson Electric Motor, not the ones that I pulled out of the kit. Our F-P motor only had 19 teeth, not 21 and was not the same motor as last year. I have already contacted the appropriate people at the motor manufacturer and should have the info by the end of the day tomorrow. As soon as I confirm, I will post all specs and drawings that I receive. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor specs | Caitlyn691 | Motors | 34 | 17-01-2003 13:33 |
| Q&A Discuss: Are specs available on the new motors/mounts? | CD47-Bot | Extra Discussion | 3 | 15-01-2003 19:39 |
| motor specs? | Gary Dillard | Motors | 0 | 04-01-2003 17:54 |
| On-board chip spec's | archiver | 2000 | 4 | 23-06-2002 21:55 |
| Motor specs | kmcclary | Off-Season Events | 4 | 26-10-2001 22:41 |