|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||
|
|||
|
I see that speed controllers must be used on motors and that the addition of them are not restricted (since they gave us 11 motors but only 4 speed controllers) - but, then in the update they catagorized the speed controllers as "electronics".
So my question is, if you are indeed limited to no more than $200 in "electronics" towards the $3500 (K3 rule) - and each additional one costs $115 - This means I could only add 1 (2 would put me over). That means I could only have a maximum of 5 motors being used - something is not right, does anyone else see what I talking about? Is the $200 limit for a single electronic purchased part? If so does anyone see a different limit on electronics? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| How do you connect the speed controller fans? | Iain | Electrical | 7 | 31-01-2003 07:05 |
| Speed controller fan replacement | Rickertsen2 | Electrical | 11 | 16-01-2003 08:46 |
| Ugh...PWM pin vs. Speed Controller | archiver | 2001 | 1 | 24-06-2002 00:27 |
| making speed controller digital | CharlieWilken | Electrical | 4 | 01-03-2002 20:15 |