|
|
|
![]() |
|
|||||||
|
||||||||
| View Poll Results: How Do i Program The speed Of Each Wheel | |||
| you may post new threads |
|
5 | 83.33% |
| you may post replies |
|
5 | 83.33% |
| you may post attachments |
|
4 | 66.67% |
| you may edit your posts |
|
4 | 66.67% |
| Multiple Choice Poll. Voters: 6. You may not vote on this poll | |||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||
|
|||
|
Callibration
If you haven't already load up dashboard and make sure your joysticks are callibrated correctly then duct tape those dials in place. This same thing happened to us and we spent a few hours trying to program around it and found out that with the dashboard it tells you the numerical value of the location of your joystick (.i.e it would display it at 127/127 when in the middle)
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2-week FIRST summer program @ WPI | ColleenShaver | General Forum | 20 | 31-05-2009 03:02 |
| Fried program slots? | Jeff Waegelin | Programming | 18 | 19-03-2003 18:08 |
| Ahh! Program trick confusing! | archiver | 2001 | 9 | 24-06-2002 02:26 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |